ben yukledim spectrum eskisine gore en son 8 ay oldu guncellleyeli super hizlanmis en arti deger zaten bu spectrum olmazsa olmazlar arti diseq swic seciminde de cok guzel sekilde uydulara gecebiliyorsunuz ama biraz daha basitlestirilebilirdi.Testlerden sonra daha detayli anlatirim insallah....
New firmware released for Micro G2 & Micro HD - smG2HD-120
what is new?????
1) In Digital mode, if the display was switched to the Large Constellation, then the beeper would continue to sound, but SNR changes would not change the pitch. Fixed.
2) In Spectrum mode, a beeper function is added to report the signal level at the cursor with pitch changes.
3) The spectrum sweep always was set at 3 on power up. Now the spectrum sweep is set to 3 when the firmware is upgraded, and from then on is saved as the user last set it.
4) The knob acceleration has been improved so that large changes in frequency (or positioner angle and others) can be selected easier.
5) Improve the Digital -> Search for lower levels by changing the dB threshhold from -70 to -85. This does make the search slower, but will now lock on low level signals. Tested with 20+ dB attenuator insertion.
6) Add the "lock boxes" similar to the old generation G2 software. For the G2 demodulator, these represent the same four phases of lock.
QPSK Lock
Descrambler Lock
Byte Align Lock
Viterbi Lock
For the HD demodulator the same indicators are not available so these are:
Tuner Mixer Lock
Tuner DAC Lock
FEC Lock
Demod Lock
7) Add Turkish to the language selections available.
8) On firmware upgrade, set the default BlindTune Modulation to 3. (Turn off the Low Symbol Rate search)
9) Add a mode "Analog NIT" which replaces the second LNB thermometer bar with a NIT search in the band. Switching back to the standard view is a function in the Analog menu which is a saved parameter so the user selection is retained at power on. This is working reasonably quickly for satellites like 13E or 19.2E, but can be considerably slower for some like 7E.
10) "Searching" and "Not Locked" on Digital mode was only in English. Change these message to the language in use.
11) Add a function on Digital menu "Tuning" to manually tune hard to lock signals. Normally, the demodulator will try a symbol rate and FEC (and for the BCM4506 a modulation) only for a while and if no lock will try another. This allows setting of modulation, FEC and symbol rate for demodulator and will remain with these settings until knob turned.
[Değerli Ziyaretci, linki görmeniz icin bu mesaja cevap yazmanız gerekiyorÜye olmak icin burayı tıklayınız]
Paylaş